Products
One-Component Polyurethane Waterproof Coating Exposed Hand-Applied Polyurea
Product Parameters
|
Item |
Index |
|
Adhesion (Pull-off Method), MPa |
>2 |
|
Water Resistance (Immersed in boiling water for 4 h) |
No change |
|
Alkali Resistance (Immersed in 3% NaOH solution for 7 days) |
No change |
|
Acid Resistance (Immersed in 2% HCl solution for 7 days) |
No change |
|
Water Impermeability |
Impermeable under 0.4 MPa for 2 hours |
Basic Parameters (25°C, 55% Relative Humidity)
|
Parameter |
Specification |
Parameter |
Specification |
|
Color |
White/Light Gray |
Specific Gravity |
1.3-1.4g/cm³ |
|
Surface Gloss |
High Gloss |
Surface Drying Time |
≤8h |
|
Component |
Single-component |
Hard Drying Time |
≤24h |
|
Solid Content |
≥85% |
Tensile Strength |
5-6MPa |
|
Recommended Total Dry Film Thickness |
1-2mm |
Elongation at Break |
≥450% |
|
Tear Strength |
35N/mm |
- |
- |
Application Scope & Construction Method
Applicable to cement, concrete, ceramic and other base surfaces. Traditional roller coating or scraping are available construction methods.
Drying time
|
Substrate Temperature (℃) |
Surface Dry (h, max) |
Through Dry (h, max) |
Recoating Interval |
|
23 |
8 |
24 |
Min. 8 h, no upper limit |
Surface Preparation
The substrate surface shall be clean, free of oil, dust and other contaminants, flat and dry. Primer pretreatment is required in advance.
Environmental conditions
1.Coating ambient temperature: 0–50°C; relative humidity below 65%.
2.Substrate surface temperature shall be at least 10°C above dew point.
3.Temperature and humidity shall be measured close to the substrate.
4.Do not apply coating under harsh weather such as rain, snow, strong wind or sandstorm.
Packaging Specification
10 kg per drum
Storage
This product should be stored in a cool, dry, ventilated indoor warehouse, storage period of half a year.
Safety
All fire sources are strictly prohibited in the batching and construction sites, and good ventilation is maintained. Lacquer splash on the skin should be washed immediately with soapy water, splash into the eyes, should be immediately washed with plenty of water, and then find a doctor to check.
Construction steps
First step clean the foundation, fill in the gaps
Second Step, Roll primer
Third step self-leveling cold polyurea floor construction
Forth step Brush waterbased PU top coat